Comfy seat with hip pads

Grey mini-cell non absorbent seats with an embossed textile covering and attached hip pads Universal fit that can be adjusted by ‘packing out’ if necessary and glued in place easily
Width 380mm Length 340 Height 150mm Customers ordering this seat can request free off-cuts to make a back support for the seat bulkhead

£40 + postage. (subject to availability)

Maroske fittings in ABS

3D Printed maroske fittings in various sizes from nylon engineering plastic in Grey or Ivory white. They can be glued in place with hybrid sealant or epoxy, and accept bungy or cord up to 6mm thick

(These fittings cannot, yet, be cost effectively produced by us, they can still be home printed)

If you have access to a 3D printer… ask us about STL files, kit customers get a free download

Shrike covers

‘Top Notch’ acrylic canvas Shrike covers with quick release straps, especially made to fit all standard sized Shrike kayak decks. With cord tensioned opening on one end, to accommodate slight variations in hull lengths. Can be made in other colours, on request

Made to order

£200 + postage

‘Slide back’ Skeg unit

3D printed ABS module that is glued into a slot cut in the hull, comes with attachment blocks and 2 x ply, laser cut, skegs. Can be installed in any 3-4mm chined, wood or composite hull, instead of a retractable unit. The housing does not protrude inside the rear compartment, the skeg can also be easily slid on or off by companion paddlers, whilst afloat. Experiment with your own skeg designs using 4mm ply offcuts. (skegs come plain and need waterproof coating)

£65 + postage (subject to availability)